Moving the Secure System Jumper
Step 6: Replace
Driveplate
Holding the driveplate vertically, align the metal extension tabs
on the base of the driveplate with the corresponding slots along
the front of the system unit.
Reconnect the driveplate power connector
!
, and replace the
driveplate.
Gently tilt the entire driveplate backward as shown in
Figure 11–5 until it returns to its former horizontal position.
Figure 11–5 Replacing the Driveplate
MLO-009208
A .......... TLZ06
B .......... RX26
C .......... TZK10
D .......... TZ30
E .......... RRD42
A
B
C
D
E
1
11–10 Using the Password Security Feature
To Next Page
Loading...