Connecting to a 10BASE2 (ThinWire) Ethernet Network
Step 2:
Ethernet Cable
Connect an AUI Ethernet cable (BNE4C-xx) to the AUI port on
the rear of the system unit, shown in Figure 5–1 of this chapter.
Step 3:
DECXM
Transceiver
Connect the other end of the AUI Ethernet cable to the AUI port
on the DECXM transceiver, as shown in Figure 5–3.
Figure 5–3 Connecting the AUI Ethernet Cable to the DECXM
Transceiver
MLO-011208
Connecting Your System to a Network 5–9
To Next Page
Loading...