DEC 600s - The Test Command

The test Command
The test Command
Command
Description
The test command lets you run diagnostic tests on the
components listed in Table 9–6:
Table 9–6 Diagnostic Tests
Test Name Device Tested
ASIC Application-specific integrated circuit
MEM Memory
NVR Non-volatile RAM and time-of-year (TOY) clock
SCC Serial communications controller
NI Network interface (Ethernet)
SCSI SCSI device(s)
ISDN
1
79C30A AMD chip
TCn TURBOchannel options, where n is the number of
the TURBOchannel device you wish to test
1
Running ISDN diagnostic tests also tests the audio port
Command
Syntax
Issue the test command as follows:
>>> test component
Return
where component is any of the components listed previously. If
you issue the test command without specifying a component, the
system will test all components. For more information about the
test command, see Chapter 14.
9–18 Using Console Commands