Unpacking a Workstation System
Save These
Parts for Later
You do not need the parts shown in Figure 2–4 during
installation. However, please save them for future use.
Figure 2–4 Components and Parts to Save
10BASE-T Loopback
Connector
Modem Loopback
Connector
Printer Port
Terminator
Antistatic
Wrist Strap
Screwdriver
MLO-011247
Network
Label
For Users in
Germany
To comply with certain international standards, Digital includes
German regulatory information (sometimes referred to as the
FTZ postcard) in every system and monitor box. Disregard this
material if your system is not located in Germany.
For Users In
Australia
The yellow warning label attached to the shipping container and
system unit is required by the country of Australia for systems
that provide ISDN functionality but are not yet certified for use
in Australia. Disregard these labels if your system is not located
in Australia.
2–8 Preparing to Install Your System
To Next Page
Loading...