Connecting the Workstation
Step 3: Monitor
Video Cable to
System Unit
Connect the other end of the monitor video cable to the graphics
connector on the system unit, as shown in Figure 3–2. The
graphics connector extends from one of the three TURBOchannel
slots on the rear of the system unit. Preconfigured systems use
Slot 0. Tighten the thumbscrews on both sides of the connector
to ensure the cable is securely connected.
Figure 3–2 Connecting the Monitor Video Cable
MLO-008599
ISDN
S3
2
1
0
3–8 Installing a Workstation System
To Next Page
Loading...