DSE Model 5110 Automatic Start Engine Management Instrumentation System
Part No. 057-009 5110 Operating Manual Issue 3.3 3/1/2006 47
18.4 INPUT EXPANSION
It is possible to increase the number of monitored inputs available by utilising a DSE 54x Protection
Expansion/Annunciator. Please refer to our Technical department for details.
18.5 STANDBY GENERATING SET?
The 5110 needs to be given a remote start signal to initiate an engine start. This can be supplied by a
Mains/Utility monitoring module to make the generating set start up automatically should the mains/utility
supply fail. The 5110 module may be used in conjunction with DSE Automatic transfer switch controllers
such as the model 500 (pictured below), 705 or 530. These not only monitor the mains and issue a start
command to the 5110 they also provide control of the contactors or other changeover devices. Please
refer to our Technical department for details.
Model 500
Deep Sea
Electronics plc
18.6 FULLY INTEGRATED AUTO MAINS FAILURE
The 5110 module can easily be replaced with a 5220 automatic mains failure controller. It has exactly the
same mounting details and uses exactly the same rear connectors. Upgrading provides integral mains
(utility) monitoring and changeover functions in the same controller. Please refer to our website for details
(http://www.deepseaplc.com)
To Next Page
Loading...
Need help?
General
