DEEP SEA ELECTRONICS DSE7400 - Maintenance Alarm Reset; Module Pin

SCADA
135
5.16.7 MAINTENANCE ALARM RESET
Three maintenance alarms active in the control module. Each is reset individually; only one alarm is shown
below for clarity.
5.16.8 MODULE PIN
NOTE : If the PIN is lost of forgotten, it will not be possible to access the module!
Allows a PIN (Personal Identification Number) to be set in the controller. This PIN must be entered to either
access the front panel configuration editor or before a configuration file can be sent to the controller from the
PC software.
Enter the desired PIN
number and reconfirm.
Click to set the
PIN number in
the module.
Reset the maintenance
alarm based upon the
module’s configuration.