9.2.3 Running detection
The controller can be configured to receive engine running feedback from a variety of measurements.
More information
See GENSET controller, GENSET controller principles, Running detection for more information.
9.2.4 Regulation
The EMERGENCY genset controller regulates the engine governor (GOV) and can also regulate the generator AVR.
More information
See Regulation for more information.
9.2.5 Power management
The EMERGENCY genset controller works together with the other controllers in the system to provide efficient power management.
More information
See Power management for more information.
9.2.6 Load sharing
During Harbour mode, the EMERGENCY genset controller shares the load with other DEIF controllers using the DEIF network.
More information
See Power management, Load sharing for more information.
9.2.7 AC configuration
More information
The AC configuration and nominal settings chapter describes the AC configuration in general.
The following table shows how the general AC configuration description applies to the EMERGENCY genset controller.
Table 9.4
AC configuration for the EMERGENCY genset controller
EMERGENCY genset General name
Generator [Source]
Busbar [Busbar]
9.2.8 Breaker configuration
More information
The Breakers, synchronisation and de-loading chapter describes breaker configuration in general. For the
EMERGENCY genset controller, replace "[Breaker]" with "Generator breaker" and "Tie breaker" in these descriptions.
9.3 Engine start
9.3.1 Engine start function
The controller software includes pre-programmed genset start sequences.
DESIGNER'S HANDBOOK 4189340911K UK Page 325 of 521
To Next Page
Loading...
