Analogue input alarms
You must complete the Sensor setup before configuring any analogue input alarms.
You can configure any number of alarms for an analogue input. However, you cannot exceed the maximum number of customised
alarms for the controller.
13.2.6 Analogue output characteristics and configuration
Symbol
Hardware modules
GAM3.1 (PWM)
GAM3.2 (PWM)
GAM3.1 (current or voltage)
GAM3.2 (current or voltage)
An analogue output (AO) can be used for regulation (for example, governor regulation or AVR regulation). Alternatively, the AO can
be used to output operating data to provide a reading on a switchboard instrument.
Analogue output function
Assign one function to the analogue output.
Analogue output setup
The output setup is required, and requires a curve. The curve allows the controller to convert the selected function's value to the
analogue output.
You can select a previously customised curve, select a pre-configured curve, or customise a curve.
DESIGNER'S HANDBOOK 4189340911K UK Page 421 of 521
To Next Page
Loading...
