Deif PPM 300 - BUS TIE Breaker Controller Overview

12. BUS TIE breaker controller
12.1 BUS TIE breaker controller overview
12.1.1 Description
Each BUS TIE breaker controller controls one bus tie breaker. Before closing the bus tie breaker, the power management system
synchronises the busbar sections.
Before opening the bus tie breaker, the power management system de-loads the bus tie breaker. The power management system
also ensures that enough power is available on each busbar section after the bus tie breaker opens.
12.1.2 Applications
There is no restriction on the number of BUS TIE breaker controllers. There can be a ring busbar connection.
Figure 12.1
Example of a BUS TIE breaker controller application
Genset
Shaft generator
G
G
BUS TIE
breaker
controller
SHAFT
generator
controller
GENSET
controller
Genset
G
GENSET
controller
DEIF network
Display
12.1.3 BUS TIE breaker controller functions
Functions
Pre-programmed
sequences
• Bus tie breaker open sequence (with de-loading), to split the busbar into sections
DESIGNER'S HANDBOOK 4189340911K UK Page 400 of 521