Deif PPM 300 - 3.8 ACM Module General Protections; ACM 1 Data Is Missing

This alarm can occur if the ACM has unintentionally restarted, or if the ACM configuration data was not received within the time limit.
Contact DEIF support if you see this error.
The alarm action is Warning, and the alarm is always enabled. The alarm parameters are not visible.
3.8.2 ACM 1 data is missing
The alarm communicates that the data protocol in the alternating current module (ACM) is not correct.
This can occur when the ACM software version is incorrect. Contact DEIF support if you see this error.
The alarm action is Warning, and the alarm is always enabled. The alarm parameters are not visible.
DESIGNER'S HANDBOOK 4189340911K UK Page 89 of 521