Table 3.15 [Source] phase angle analogue output functions
Function Details
[Source] > Phase angle > [Equipment] | Phase angle L1-L2
[degrees]
The controller outputs the phase angle between L1 and L2.
[Source] > Phase angle > [Equipment] | Phase angle L2-L3
[degrees]
The controller outputs the phase angle between L2 and L3.
[Source] > Phase angle > [Equipment] | Phase angle L3-L1
[degrees]
The controller outputs the phase angle between L3 and L1.
[Source] > Phase angle > [Equipment] | A-B phase angle L1
[degrees]
The controller outputs the phase angle between L1 of the
source and L1 of the busbar.
[Source] > Phase angle > [Equipment] | A-B phase angle L2
[degrees]
The controller outputs the phase angle between L2 of the
source and L2 of the busbar.
[Source] > Phase angle > [Equipment] | A-B phase angle L3
[degrees]
The controller outputs the phase angle between L3 of the
source and L3 of the busbar.
3.3.3 [Busbar] AC measurements
Assign the AC measurement function to an analogue output under Configure > Input/output. Select a hardware module with an
analogue output, then select the output to configure.
Function names
The busbar AC measurement function names follow these formats:
[Busbar] > [Physical quantity] > [Equipment] | [Measurement] [[unit]]. For example, Busbar A > Apparent power (S) > Busbar A
| Total [kVA].
Table 3.16
[Busbar] AC measurement function names for each controller type
Controller type [Busbar] [Equipment]
GENSET Busbar Busbar
EMERGENCY genset Busbar Busbar
SHAFT generator Busbar Busbar
SHORE connection Ship busbar Busbar
BUS TIE breaker Busbar B Busbar B
Table 3.17 [Busbar] voltage analogue output functions
Function Details
[Busbar] > Voltage (V) > [Equipment] | L1-N [V AC] The controller outputs the L1-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L2-N [V AC] The controller outputs the L2-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L3-N [V AC] The controller outputs the L3-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | N [V AC] The controller outputs the N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L1-L2 [V AC] The controller outputs the L1-L2 voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L2-L3 [V AC] The controller outputs the L2-L3 voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L3-L1 [V AC] The controller outputs the L3-L1 voltage from the busbar
[Busbar] > Voltage (V) > [Equipment] | Positive sequence [V
AC]
The controller outputs the magnitude of the positive sequence
voltage.
DESIGNER'S HANDBOOK 4189340911K UK Page 59 of 521
To Next Page
Loading...
