Deif PPM 300 - Page 52

L3
S1
S2
L2
S1
S2
L1
S1
S2
L1
L1
L2
L2
L3
L3
N
N
ACM3.1
*
S1
S2
4
1
2
3
4
1. [Busbar] voltage measurements
2. [Source] voltage measurements
• For example: GENSET controller: The voltage at the genset
3. [Source] current measurements
• For example: GENSET controller: The current from the genset
4. 4th current measurement
• For example: Earth current
Inputs and outputs
Assign the nominal settings inputs and outputs under Configure > Input/output. Select the hardware module, then select the input/
output to configure.
Table 3.1
Nominal settings inputs and outputs
Function I/O Type Details
Local > Nominal settings >
Controller nominal setting > Nominal
setting #
Digital input Pulse
The controller changes the active nominal setting group
to the nominal setting group assigned to the digital
input.
Local > Nominal settings >
Controller nominal setting > Nominal
setting # selected
Digital output Continuous
Activated if the active nominal setting group is the same
as the nominal setting group configured to the output.
Local > Nominal settings >
Controller nominal setting > Nominal
setting #
Analogue input
Supervised
binary input
The controller changes the active nominal setting group
to the nominal setting group assigned to the analogue
input. The input signal is treated by the controller as a
pulse signal.
Local > Nominal settings >
Controller nominal setting > Nominal
setting # selected
Analogue
output
0 to 3
The controller outputs a number correlating to the
active nominal setting group. Where Nominal setting 1
is zero.
Parameters
INFO
See the chapter for the specific controller type for the nominal setting parameters for voltage, current and generator speed
(if applicable).
Configure these parameters under Configure > Parameters > Local > Nominal settings > Controller nominal setting.
DESIGNER'S HANDBOOK 4189340911K UK Page 52 of 521