Controller type [Source] [Equipment]
SHORE connection Shore busbar Shore
BUS TIE breaker Busbar B Busbar A
Table 3.7 [Source] voltage analogue output functions
Function Details
[Source] > Voltage (V) > [Equipment] | L1-N [V AC] The controller outputs the L1-N voltage from the source.
[Source] > Voltage (V) > [Equipment] | L2-N [V AC] The controller outputs the L2-N voltage from the source.
[Source] > Voltage (V) > [Equipment] | L3-N [V AC] The controller outputs the L3-N voltage from the source.
[Source] > Voltage (V) > [Equipment] | N [V AC]
The controller outputs the N voltage from the source, relative to the
star point.
[Source] > Voltage (V) > [Equipment] | L1-L2 [V AC] The controller outputs the L1-L2 voltage from the source.
[Source] > Voltage (V) > [Equipment] | L2-L3 [V AC] The controller outputs the L2-L3 voltage from the source.
[Source] > Voltage (V) > [Equipment] | L3-L1 [V AC] The controller outputs the L3-L1 voltage from the source.
[Source] > Voltage (V) > [Equipment] | Positive sequence
[V AC]
The controller outputs the magnitude of the positive sequence
voltage.
[Source] > Voltage (V) > [Equipment] | Negative sequence
[V AC]
The controller outputs the magnitude of the negative sequence
voltage.
[Source] > Voltage (V) > [Equipment] | Zero sequence [V
AC]
The controller outputs the magnitude of the zero sequence voltage
from the source.
[Source] > Voltage (V) > [Equipment] | L-N min. [V AC]
The controller outputs the lowest L-N voltage (that is, for the phase
with the lowest L-N voltage).
[Source] > Voltage (V) > [Equipment] | L-N max. [V AC]
The controller outputs the highest L-N voltage (that is, for the phase
with the highest L-N voltage).
[Source] > Voltage (V) > [Equipment] | L-N unbalanced [V
AC]
The controller outputs the L-N unbalanced voltage from the source,
relative to the zero of the star point.
[Source] > Voltage (V) > [Equipment] | L-L min. [V AC]
The controller outputs the lowest L-L voltage (that is, for the phases
with the lowest L-L voltage).
[Source] > Voltage (V) > [Equipment] | L-L max. [V AC]
The controller outputs the highest L-L voltage (that is, for the phases
with the highest L-L voltage) from the source.
[Source] > Voltage (V) > [Equipment] | L-L unbalanced [V
AC]
The controller outputs the L-L unbalanced voltage between the
phases of the source.
Table 3.8 [Source] frequency analogue output functions
Function Details
[Source] > Frequency (f) (from voltage) > [Equipment] | L1
[Hz]
The controller outputs the L1 frequency (based on the voltage
measurement).
[Source] > Frequency (f) (from voltage) > [Equipment] | L2
[Hz]
The controller outputs the L2 frequency (based on the voltage
measurement).
[Source] > Frequency (f) (from voltage) > [Equipment] | L3
[Hz]
The controller outputs the L3 frequency (based on the voltage
measurement).
[Source] > Frequency (f) (from voltage) > [Equipment] |
Min. [Hz]
The controller outputs the frequency of the phase with the lowest
frequency (based on the voltage measurement).
[Source] > Frequency (f) (from voltage) > [Equipment] |
Max. [Hz]
The controller outputs the frequency of the phase with the highest
frequency (based on the voltage measurement).
DESIGNER'S HANDBOOK 4189340911K UK Page 55 of 521
To Next Page
Loading...
