No. Output source Description
47 Gross over speed shutdown
This output is activated when the shutdown alarm for gross overspeed is
activated.
48 Start relay
This output is activated when the start relay is activated during the engine
start sequence.
49 Temp sensor open circuit
This output is activated when the alarm for the temperature sensor (open
circuit) is activated.
50 Under freq shutdown
This output is activated when the shutdown alarm for under-frequency is
activated.
51 Under speed shutdown
This output is activated when the shutdown alarm for under-speed is
activated.
52 Maintenance due This output is activated when the maintenance alarm is activated.
53 Stop mode This output is activated when the stop sequence is initiated.
54 Auto mode This output is activate when the controller is in AUTO mode.
55 Manual mode This output is activate when the controller is in manual mode.
56 Preheat output
This output is activated when the pre-heater is activated. The output is
active for the duration of the pre-heat timer.
57 Automatic fuel transfer
This output is activated when the automatic fuel transfer output is
activated.
58 ISV pull signal
This output is high when the start command is given. The output is high for
an adjustable time.
59 ISV hold signal
This output is activated when the start command is given. The output is
deactivated when the stop command is given and the engine has stopped.
60 Low idle mode This output is activated when the genset is operating at low idle speed.
61 Coolant control output
This output is activated when the coolant temperature is outside the set
points configured for the temperature.
62 Keyswitch
This output is active during the start sequence. It is not active during the
stop sequence.
63 Open Gen Breaker Pulse If this output is activated, a pulse is generated to open the genset breaker.
64 Close Gen Breaker Pulse If this output is activated, a pulse is generated to close the genset breaker
65 Open Mains Breaker Pulse If this output is activated, a pulse is generated to open the mains breaker
66 Close Mains Breaker Pulse If this output is activated, a pulse is generated to close the mains breaker
67 Idle Mode On Pulse If this output is activated, a pulse is generated to activate idle mode.
68 Idle Mode Off Pulse If this output is activated, a pulse is generated to deactivate idle mode.
User manual 4189341340A EN Page 74 of 76
To Next Page
Loading...
