Figure 77. Removing the right control panel
Next step
1 Install the right control panel.
Installing the right control panel
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
3 Remove the front bezel.
4 Remove the air shroud.
Steps
1 Route the control panel cable through the side and the guide slots in the system.
NOTE
: Route the cable properly to prevent the cable from being pinched or crimped.
2 Align and insert the right control panel assembly in the slot on the system.
3 Connect the control panel cable to the system board connector.
4 Using the appropriate screwdriver, replace the screws that secure the right control panel to the system.
104
Installing and removing system components
To Next Page
Loading...
