Figure 29. Removing a cabled drive
Next step
1 Install the drive into the drive carrier.
Installing a cabled drive
Prerequisites
1 Follow the safety guidelines listed in the Safety instructions.
2 Follow the procedure listed in the Before working inside your system.
CAUTION
: Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 inch-pounds.
Steps
1 Insert the drive into the drive slot until the release button clicks into place.
2 Connect the power and data cable connector to the drive.
Installing and removing system components
59
To Next Page
Loading...
