Setting Copy Options
The Copy menus on the operator panel let you customize all the basic copy options; number of copies, copy size, contrast and image quality. Set the following
options for the current copy job before pressing Start ( ) to make copies.
Number of Copies
You can select the number of copies from 1 to 199.
1. Press Scroll ( or ) to highlight Copy and press Select ( ).
2. Press Select ( ) to access # of copies.
3. Enter the value you want using the number keypad.
Reduced/Enlarged Copy
You can reduce or enlarge the size of a copied image, from 25 percent to 400 percent when you copy original documents from the document glass or from 25
percent to 100 percent from the ADF. Note that the zoom rate available is different depending on the document loading method.
To select from the predefined copy sizes:
1. Press Scroll ( or ) to highlight Copy and press Select ( ).
2. Press Scroll ( or ) to highlight Zoom and press Select ( ).
3. Press Scroll ( or ) to find the size setting you want and press Select ( ).
To fine-tune the size of copies:
1. Press Scroll ( or ) to highlight Copy and press Select ( ).
2. Press Scroll ( or ) to highlight Zoom and press Select ( ).
3. Press Scroll ( or ) to display Other (25-400) (from the document glass) or Other (25-100) (from the ADF) and press Select ( ).
4. Enter the value you want using the number keypad.
Contrast
Adjust the contrast to make the copy lighter or darker than the original.
1. Press Scroll ( or ) to highlight Copy and press Select ( ).
2. Press Scroll ( or ) to highlight Contrast and press Select ( ).
3. Press Scroll ( or ) to adjust the contrast.
Quality
You can use the Quality settings to improve the image quality by selecting the document type for the current copy job.
1. Press Scroll ( or ) to highlight Copy and press Select ( ).
2. Press Scroll ( or ) to highlight Quality and press Select ( ).
To Next Page
Loading...
Need help?
General
