Dell 2355dn

148
6 If necessary, customize the copy settings including number of copies, contrast, original size,
and original type. See "
Setting Copy Options".
7 Press to go to the upper menu.
8 Press Start ( ) . (on the touch screen or the operator panel)
NOTE: You can cancel the copy job at any time. Press , and the copying will stop.
Collate Copying
This special copy mode can be applied when you load a document using only the DADF.
To make the
Collate copying:
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass.
For details about loading a document, see "
Loading an Original Document".
2 Press Copy from the home screen.
3 Press the left/right arrows to select Collate Copy .
4 If necessary, customize the copy settings including number of copies, contrast, original type,
and original size by pressing
Options . See "Setting Copy Options".
5 Press to go to the upper menu.
6 Press Start ( ) . (on the touch screen or the operator panel)
NOTE: You can cancel the copy job at any time. Press , and the copying will stop.
Auto Fit Copying
This special copy mode can be applied when you load a document using only the document glass.
If a document is detected in the DADF, the
Auto Fit does not work.
. NOTE: You cannot adjust the copy size using the Zoom menu while the Auto Fit copying is
enabled.
To make the Auto Fit copying:
1 Place a single document face down on the document glass.
For details about loading a document, see "
Loading an Original Document".
2 Press Copy from the home screen.
3 Press the left/right arrows to select Auto Fit Copy .
4 If necessary, customize the copy settings including number of copies, contrast, original type,
and original size by pressing
Options . See "Setting Copy Options".
A