Networking
Setting Up a Network-connected Printer
Sharing the Printer on a Network
OpenSSL License
Original SSLeay License
Setting Up a Network-connected Printer
To use this printer as your network printer, you must set up network parameters on it. Network parameters can be set up
by the following two methods:
Via Network Administration Programs
You can configure your printer's print server settings and manage it via the following programs:
Embedded Web Service: A web server embedded to your network print server, which allows you to:
Configure the network parameters necessary for the printer to connect to various network environments.
NOTE: For details on how to access the Embedded Web Service please refer to the chapter, "Dell Printer
Configuration Web tool."
SetIP Address: A utility program allowing you to select a network interface card and manually configure the
addresses for use with the TCP/IP protocol. See
"Set IP Address Utility".
Via the Operator Panel
You can configure the basic network parameters through the printer's operator panel. Use the printer operator panel
to do the following:
Print a Network Configuration Page
Configure TCP/IP
Configure EtherTalk
Configure IPX/SPX
Configure a Wireless Network
Configuring Network Parameters on the Operator Panel
To Next Page
Loading...
