Dell 5330dn - Workgroup Laser Printer B/W - Restoring the Network Configuration; Sharing the Printer on a Network

6. The first available menu item, IP Address displays.
7. To enter the numbers, use Scroll ( to ) and Scroll ( to ) to move between octets and press Select (
).
8. Enter other parameters, such as the Subnet Mask or GateWay, and press Select (
).
9. After entering all parameters, press Cancel (
) to return to Standby mode.
Dynamic Addressing (BOOTP/DHCP)
To assign the TCP/IP address automatically using a DHCP or BOOTP server on your network, perform the following steps:
1. Press Menu ( ).
2. Press Scroll (
to ) to highlight Network I/O Ports and press Select ( ).
3. Press Scroll (
to ) to highlight TCP/IP(IPv4) and press Select ( ).
4. Press Scroll (
to ) to highlight Set IP Address and press Select ( ).
5. Press Scroll (
to ) to highlight DHCP and press Select ( ).
To assign the address from the BOOTP server, press Select (
) when BOOTP displays.
Restoring the Network Configuration
You can return the network configuration to its default settings.
1. Press Menu ( ).
2. Press Scroll (
to ) to highlight Network I/O Ports and press Select ( ).
3. Press Scroll (
to ) to highlight Clear Settings and press Select ( ).
4. Press Scroll (
to ) to highlight Yes and press Select ( ).
5. Power the printer off and back on.
Setting a Wireless network (Optional wireless network card)
To use the Dell 5330dn Mono Laser Printer in both wired and wireless network environments, you can install an
optional wireless network card. For details of Wireless setup, please refer to "Quick Install Guide" for the wireless network
interface card.
Sharing the Printer on a Network