Dell 5330dn - Workgroup Laser Printer B/W - Page 92

If you selected AppleTalk.
a. Press Scroll ( to ) to highlight Activate and press Select ( ).
b. Press Scroll (
to ) to change the setting to On (enable) or Off (disable).
If you selected Wireless, assign a wireless network environment. For details, see
"Configuring TCP/IP".
NOTE: When you set AppleTalk, you must restart your machine to apply new settings.
5. Press Select ( ) to save the selection.
Configuring TCP/IP
Static Addressing: TCP/IP address is assigned manually by the system administrator.
Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or BOOTP server
on your network.
Setting TCP/IP
To enter the TCP/IP address from your printer's operator panel, take the following steps:
1. Press Menu ( ).
2. Press Scroll (
to ) to highlight Network I/O Ports and press Select ( ).
3. Press Scroll (
to ) to select the network protocol you want to use and press Select ( ).
If you selected TCP/IP(IPv4):
a. Press Scroll (
to ) to highlight IPv4 Activate and press Select ( ).
b. Press Scroll (
to ) to change the setting to On (enable) or Off (disable).
If you selected TCP/IP(IPv6):
a. Press Scroll (
to ) to highlight IPv6 Activate and press Select ( ).
b. Press Scroll (
to ) to change the setting to On (enable) or Off (disable).
d. Press Cancel (
) to return to Standby mode.
Static Addressing
To enter the TCP/IP address from your printer's operator panel, take the following steps:
1. Press Menu ( ).
2. Press Scroll (
to ) to highlight Network I/O Ports and press Select ( ).
3. Press Scroll (
to ) to highlight TCP/IP(IPv4) and press Select ( ).
4. Press Scroll (
to ) to highlight Set IP Address and press Select ( ).
5. Press Scroll (
to ) to highlight Manual and press Select ( ).