Replacing the power-adapter
port
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Slide the power-adapter port into the slot on the computer base.
2 Align the screw holes on the power-adapter port bracket with the screw holes
on the power-adapter port.
3 Replace the screws that secure the power-adapter port bracket to the power-
adapter port.
4 Route the power-adapter port cable through the routing guides on the
computer base.
Post-requisites
1 Follow the procedure from step 4 to step 10 in “Replacing the system board”.
2 Replace the display assembly.
3 Follow the procedure from step 5 to step 11 in “Replacing the palm rest”.
4 Replace the wireless card.
5 Replace the base panel.
44
Replacing the power-adapter port 101
To Next Page
Loading...
