Replacing the battery
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Align the screw holes on the battery with the screw holes on the computer
base.
2 Replace the screws that secure the battery to the computer base.
3 Slide the battery cable through the slot on the computer base.
4 Adhere the front AlienFX LED cable to the battery.
5 Route the speaker cable through the routing guides on the battery.
6 Connect the speaker cable and front AlienFX LED cable to the system board.
Post-requisites
1 Follow the procedure from step 5 to step 11 in “Replacing the palm rest”.
2 Replace the base panel.
24
Replacing the battery 64
To Next Page
Loading...
