Replacing the power-button
board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more
safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Align the screw holes on the power-button board with the screw holes on the
palm-rest assembly.
2 Replace the screws that secure the power-button board to the palm-rest
assembly.
3 Connect the power-button board cable to the power-button board.
4 Slide the touch-pad cable and the status-light cable into their respective
connectors on the power-button board and press down the latches to secure
the cables.
Post-requisites
1 Follow the procedure from step 5 to step 11 in “Replacing the palm rest”.
2 Replace the base panel.
14
Replacing the power-button board 41
To Next Page
Loading...
