Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive, if applicable.
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in After working inside your computer.
Wireless antenna module
Internal antenna module
Removing the internal antenna module
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 3.5-inch hard drive, if applicable.
5. Remove the disk-drive cage.
6. Remove the wireless card.
About this task
The following images indicate that the location of the internal antenna module and provide a visual representation of the removal
procedure.
82
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
Need help?
General