EasyManuals Logo

Dell OptiPlex Small Form Factor Plus 7020 User Manual

Dell OptiPlex Small Form Factor Plus 7020
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
Figure 48. Removing the power-supply unit
Steps
1. Disconnect the power-supply cables from their connectors (ATX CPU1, ATX CPU2 and ATX SYS) on the system board.
2. Remove the power-supply cables from the routing guides on the chassis.
3. Remove the three screws (#6-32) that secure the power-supply unit to the chassis.
4. Slide and lift the power-supply unit off the chassis.
Installing the power-supply unit
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
91

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell OptiPlex Small Form Factor Plus 7020 and is the answer not in the manual?

Dell OptiPlex Small Form Factor Plus 7020 Specifications

General IconGeneral
BrandDell
ModelOptiPlex Small Form Factor Plus 7020
CategoryDesktop
LanguageEnglish

Related product manuals