Dell POWERCONNECT 5524P

102 Dell PowerConnect 55xx Systems User Guide
– Dest. MAC Address — Match the destination MAC address to which
packets are addressed to this address. In addition to the Destination
MAC address, you can enter a
Wildcard Mask that specifies which
bits in the source address are used for matching and which bits are
ignored. A wildcard of 00:00:00:00:00:00 means the bits must be
matched exactly; ff:ff:ff:ff:ff:ff means the bits are irrelevant. Any
combination of 0s and ffs can be used.
–
Any — Check to indicate that the destination address is not matched.
–
VLAN ID — Match the packet’s VLAN ID to this VLAN ID. The
possible VLAN IDs are 1 to 4095.
–
CoS — Match the packet’s CoS value to this CoS value.
–
Cos Mask — Match the packet’s CoS value to one of these CoS
values.
–
Ether type — Match the packet’s Ethertype to this one.
–
Time Range Name — Check to associate a time range with the ACE.
Select one of the time ranges defined in the
Time Range page.
–
Action — Select the action taken upon a match. The following
options are available:
•
Permit — Forward packets that meet the ACL criteria.
•
Deny — Drop packets that meet the ACL criteria.
•
Shutdown — Drop packets that meet the ACL criteria, and
disable the port to which the packet was addressed.
–
Logging of Dropped Packets — Check to activate logging of dropped
packets.