Dell POWERCONNECT 5524P

Dell PowerConnect 55xx Systems User Guide 105
Configuring IP-based ACLs Using CLI Commands
The following table summarizes the CLI commands for configuring I
P-based
ACLs
.
The following is an example of some of the CLI commands:
IPv4-Based ACEs
To add a rule to an ACL:
1
Click Switching > Network Security > IPv4 Based ACE to display the
IPv4 Based ACE page.
Figure 8-5. IPv4 Based ACE: Summary
Table 8-4. IP-Based ACL CLI Commands
CLI Command Description
ip access-list extended acl-
name
no ip access-list extended acl-
name
Defines an IPv4 access list and places
the device in IPv4 access list
configuration mode
Use the no form of this command to
remove the access list.
console(config)# ip access-list extended server-acl