Dell POWERCONNECT 5524P - Page 117

Dell PowerConnect 55xx Systems User Guide 117
The following is an example of some of the CLI commands:
deny protocol {any|{source-prefix/length
}{any|destination-prefix|length} [dscp
number|precedence number] [time-range
time-range-name] [disable-port|log-input]
deny icmp {any|{source-prefix/length
}{any|destination-prefix/length }
{any|icmp-type} {any|icmp-code} [dscp
number|precedence number] [time-range
time-range-name] [disable-port|log-input]
deny tcp {any|{source-prefix/length }
{any|source-port/port-range}
}{any|destination-prefix/length}
{any|destination-port/port-range} [dscp
number|precedence number] [match-all list-
of-flags] [ti
me-range time-range-name]
[disable-port|log-input]
deny udp {any|{source-prefix/length }}
{any|source-port/port-range}
}{any|destination-prefix|length}
{any|destination-port/port-range} [dscp
number|precedence number] [time-range
time-range-name] [disable-port|log-input]
Sets deny conditions
for IPv4 access list (in
Access List
Configuration mode).
console(config)# ipv6 access-list server
console(config-ipv6-al)# permit tcp 3001::2/64 any any 80
Table 8-7. IP-Based ACE CLI Commands (Continued)
CLI Command Description