210 Dell PowerConnect 55xx Systems User Guide
Configuring DHCP IPv4 Interfaces Using CLI
The following is a sample CLI script to configure a dynamic IPv4 address on
an interface and then to remove it:
IPv4 Static Routing
IPv4 static routes can be configured for IP addresses that are not on directly
connected networks. These are defined in the IPv4 Static Routing pages.
Table 9-22. Sample CLI Script to Configure IPv4 Dynamically on a VLAN
CLI Command Description
console#config Enter Global Configuration
mode.
console(config)# interface vlan 1 Enter VLAN mode for VLAN
1.
console(config)# no switchport Enable the port to work as an
IP interface (Layer 3 mode).
console(config-if)# ip address dhcp Use the DHCP protocol to
acquire the IP address.
console(config-if)# no ip address
dhcp
Remove the address (if
required).
Table 9-23. Sample CLI Script to Configure IPv4 Dynamically on a Port
CLI Command Description
console#config Enter Global Configuration
mode.
console(config)# interface vlan 1 Enter VLAN mode for VLAN
1.
console(config-if)# ip address dhcp Use the DHCP protocol to
acquire the IP address.
console(config-if)# no switchport Enable the port to work as an
IP interface (Layer 3 mode).
console(config-if)# no ip address
dhcp
Remove the address (if
required).
To Next Page
Loading...
