Dell PowerConnect 55xx Systems User Guide 209
The previously-configured DHCP IPv4 interfaces are displayed.
2
To add an interface that can receive an IP address, click
Add
and select the
whether the interface is a port, LAG or VLAN in the
Interface
field.
Defining DHCP IPv4 Interfaces Using CLI Commands
The following table summarizes the CLI commands for setting fields in the
DHCP IPv4 Interface pages.
Table 9-21. DHCP IPv4 Interface CLI Commands
CLI Command Description
ip address dhcp
no ip address dhcp
Acquires an IP address on an Ethernet interface
from the Dynamic Host Configuration Protocol
(DHCP).
Use the no form of this command to release an
acquired IP address.
To Next Page
Loading...
