EasyManua.ls Logo

Dell POWERCONNECT 5524P - Page 229

Dell POWERCONNECT 5524P
728 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dell PowerConnect 55xx Systems User Guide 229
The previously-defined neighbors are displayed along with their states.
The possible states are:
Incomplete
— An address resolution is in progress, and the link-layer
address of the neighbor has not yet been determined.
Reachable
— The neighbor is known to have been reachable recently
(within tens of seconds).
Stale
— The neighbor is no longer known to be reachable, but until
traffic is sent to the neighbor, no attempt is made to verify its
reachability.
Delay
— The neighbor is no longer known to be reachable, and traffic
has recently been sent to the neighbor. Rather than probe the
neighbor immediately, however, there is a delay sending probes for a
short while, in order to give upper-layer protocols a chance to provide
reachability confirmation.
Probe
— The neighbor is no longer known to be reachable, and
Unicast Neighbor Solicitation probes are being sent to verify
reachability.
2
To clear the Neighbors table, select one of the following options:
None
— Does not clear any entries.
Static Only
— Clears the static entries.
Dynamic Only
— Clears the dynamic entries.
All Dynamic and Static
— Clears the static and dynamic address
entries.
3
To add a new IPv6 neighbor, click
Add,
and enter the fields:
IPv6 Interface
— Displays the interface on which IPv6 Interface is
defined.
IPv6 Address
— Enter the neighbor IPv6 address.
MAC Address
— Enter the MAC address assigned to the interface.

Table of Contents

Related product manuals