346 Dell PowerConnect 55xx Systems User Guide
3
Select a
Firmware/Configuration
option. The possible options are:
–
Firmware Download
— A firmware file is downloaded.
–
Configuration Download
— A configuration file is downloaded.
4
Select to download firmware or a configuration file via a USB port or
HTTP in
Download Protocol
.
5
If the
Firmware Download
option was selected, enter the following:
–
Source File Name (1-64 characters)
— The file to be downloaded.
–
Destination File Type
— The destination file type to which the file is
downloaded. The possible options are:
•
Software Image
— Downloads the Image file. The image file
overwrites the non-active image. It is recommended to designate
that the non-active image becomes the active image after reset,
and then to reset the device following the download. During the
Image file download a dialog box opens that displays the
download progress, and browsing is disabled.
•
Boot Code
— Downloads the Boot file.
6
If the
Configuration Download
option was selected, enter the following:
–
Server IP Address
— Enter the IP address of the server.
–
Source File Name (1-64 Characters)
— Enter the source file name.
–
Destination File Name
— Select the destination file to which the
configuration file is downloaded. The possible options are:
•
Running Configuration
— Check to download commands into
the Running Configuration file. The current file is overwritten.
•
Startup Configuration —
Check to download commands into the
Startup Configuration file. The current file is overwritten.
•
New File Name (1-64 Characters)
— Check to copy commands
into a file in flash memory. Enter the filename.
7
Click
Activate
to start the download process.
To Next Page
Loading...
