Dell POWERCONNECT 5524P - Page 357

Dell PowerConnect 55xx Systems User Guide 357
– Destination Unit — Check to copy the firmware to either the Backup
Master unit or all units in the stack.
3 To copy the Running Configuration file of the Master unit to the Startup
Configuration file of the Master unit or vice versa, select
Copy
Configuration Firmware
and enter the options:
–
Source — Select either the Running Configuration or the Startup
Configuration file.
–
Destination — Select either the Running Configuration, Startup
Configuration file or user-created flash files, depending on the source
configuration file.
or
–
New File Name (1-64 characters) — To copy the source file to a
user-named file, enter the name of a file. If this option is selected,
check where the file is stored:
Flash or USB .
4 Select Restore Configuration Factory Defaults to replace the current
configuration settings by the factory configuration default settings.
5 Click Activate to initiate the selected process.
Copying Files Using CLI Commands
The following table summarizes the CLI commands for performing actions
provided by the Copy Files page.
Table 9-67. Copy Files CLI Commands
CLI Command Description
copy source-url destination-url Copies any file from a source to a
destination.
delete startup-config Deletes the startup-config file.
delete url Deletes a file from the FLASH
memory device.