Dell POWERCONNECT 5524P - Page 401

Dell PowerConnect 55xx Systems User Guide 401
set interface active
{
[gigabitethernet|tengigabitethe
rnet] interface|port-channel LAG-
number}
Reactivates an interface that is
shutdown.
speed {10|100|1000|10000}
no speed
Configures the speed of a given
Ethernet interface when not using
auto negotiation.
Use the no form of this command to
restore the default configuration.
duplex {half|full}
no duplex
Configures the full/half duplex
operation of a given Ethernet
interface when not using auto
negotiation.
negotiation [capability1
[capability2…capability5]
no negotiation
Enables auto negotiation operation
for the speed and duplex parameters
of a given interface.
Use the no form of this command to
disable auto-negotiation.
back-pressure
no back-pressure
Enables Back Pressure on a given
interface.
Use the no form of this command to
disable back pressure.
flowcontrol {auto|on|off}
no flowcontrol
Configures the flow control on a
given interface.
Use the no form of this command to
disable flow control.
mdix {on|auto}
no mdix
Enables automatic crossover on a
given interface or Port-channel.
Use the no form of this command to
disable cable crossover.
show interfaces configuration
[
[gigabitethernet|tengigabitethe
rnet] port-number
|port-channel
LAG-number]
Displays the configuration for all
configured interfaces.
Table 10-8. Port Configuration CLI Commands (Continued)
CLI Command Description