Dell POWERCONNECT 5524P - Page 405

Dell PowerConnect 55xx Systems User Guide 405
• 1000 Full — The LAG advertises for a 1000 mbps speed LAG and
full duplex mode setting.
–
Current Advertisement — Displays the speed that the LAG advertises
to its neighbor LAG to start the negotiation process. The possible field
values are those specified in the
Admin Advertisement field.
–
Neighbor Advertisement — Displays the neighboring LAG
advertisement settings. The field values are identical to the
Admin
Advertisement
field values.
–
Admin Flow Control — Enable/disable flow control on the LAG.
Flow Control mode is effective on the ports operating in Full Duplex
in the LAG. The possible options are:
•
Enable — Enables flow control on the LAG (default).
•
Disable — Disables flow control on the LAG.
•
Auto Negotiation — Enables the auto-negotiation of flow control
on the LAG.
–
Current Flow Control — Displays the current Flow Control setting.
Configuring LAGs Using CLI Commands
The following table summarizes the CLI commands for configuring LAGs as
displayed in the LAG Configuration pages.
Table 10-9. LAG Configuration CLI Commands
CLI Command Description
interface port-channel LAG-
number
Enters the interface configuration
mode of a specific LAG.
channel-group port-channel mode
{on|auto}
no channel-group
Sets a mode for a LAG.
Use the no form of this command
restore the default configuration.
description string
no description
Adds a description to a LAG.
Use the no form of this command to
remove the description.