542 Dell PowerConnect 55xx Systems User Guide
–
User Priority
— Select the traffic priority assigned to the network
application.
–
DSCP Value
— Select the value to be used by neighbors to mark the
traffic sent to the switch.
Configuring MED Network Policies Using CLI Commands
The following commands are used to configure MED network policies.
The following is an example of the CLI commands:
Table 17-3. LLDP MED Network Policies CLI Commands
CLI Command Description
lldp med network-policy number
application [vlan id] [vlan-type
{
tagged|untagged}] [up
priority
][dscp value]
no lldp med network-policy number
Defines an LLDP MED network
policy.
Use the no form of this command
to remove an LLDP MED
network policy.
console(config)# lldp med network-policy 1 voice-signaling
vlan 1