Dell PowerEdge C6220 - Page 101

Installing System Components | 101
Token
Setup option
Description
00D7
Serial port
Number
Serial Console redirection ON - output to COM2.
00D8
Load Optimal
Defaults
Requests a optimal default of SETUP values on the next
boot.
00FE
Legacy USB
Support
System does not provide legacy USB support for operating
system.
00FF
Legacy USB
Support
System provides legacy USB support for operating system.
0117
SATA Port0
Sets the 1st Serial ATA drive controller to OFF.
0118
SATA Port0
Sets the 1st Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
0119
SATA Port1
Sets the 2nd Serial ATA drive controller to OFF.
011A
SATA Port1
Sets the 2nd Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
011B
SATA Port2
Sets the 3rd Serial ATA drive controller to OFF.
011C
SATA Port2
Sets the 3rd Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
011D
SATA Port3
Sets the 4th Serial ATA drive controller to OFF.
011E
SATA Port3
Sets the 4th Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
011F
SATA Port4
Sets the 5th Serial ATA drive controller to OFF.
0120
SATA Port4
Sets the 5th Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
0121
SATA Port5
Sets the 6th Serial ATA drive controller to OFF.
0122
SATA Port5
Sets the 6th Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
0135
Embedded
SATA Controller
Disables the SATA controller. The token applies to the first
on-board SATA controller.