Dell PowerEdge C6220 - Page 80

80 | Installing System Components
Option
Description
Embedded SATA Link Rate
(Auto default)
Auto – Sets the SATA link rate at maximum.
1.5 Gbps – Sets the SATA link rate at minimum as 1.5
Gbps. For power consumption.
3.0 Gpbs – Sets the SATA link rate at minimum as 3.0
Gbps.
SATA Port 0
(Auto default)
Off – Sets the 1st Serial ATA drive controller to Off.
Auto – Sets the 1st Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
SATA Port 1
(Auto default)
Off – Sets the 2nd Serial ATA drive controller to
Off.
Auto – Sets the 2nd Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
SATA Port 2
(Auto default)
Off – Sets the 3rd Serial ATA drive controller to Off.
Auto – Sets the 3rd Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
SATA Port 3
(Auto default)
Off – Sets the 4th Serial ATA drive controller to Off.
Auto – Sets the 4th Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
SATA Port 4
(Auto default)
Off – Sets the 5th Serial ATA drive controller to off.
Auto –Sets the 6th Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
SATA Port 5
(Auto default)
Off – Sets the 6th Serial ATA drive controller to off.
Auto –Sets the 6th Serial ATA drive controller to Auto
(enabled if present, POST error if not present).
Power Saving Features
(Enabled default)
This feature will allow users to disable/enable the
feature that allows SATA HDDs to initiate link power
management transitions.
HDD Security Erase
(Disabled default)
Sets/Unlocks the HDD Security Freeze Lock.