142 Script Commands
repositoryDiskGroup The name of the replication repository
disk group where the replication repository
virtual disk is located. (To determine the
names of the disk groups in your storage
array, run the show storageArray
profile command.)
physicalDiskMediaType The type of physical disk media that you
want to use for the replication repository
disk group. Valid physical disk media are
these:
• HDD – Use this option when you have
hard physical disks in the expansion
enclosure.
• SSD – Use this option when you have
solid state physical disks in the
expansion enclosure.
• unknown – Use if you are not sure what
types of physical disk media are in the
expansion enclosure.
• allMedia - Use this option when you
want to use all types of physical disk
media that are in the expansion
enclosure.
Use this parameter when you use the
repositoryPhysicalDiskCoun
t
parameter.
You must use this parameter when you
have more than one type of physical disk
media in your storage array.
book.book Page 142 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
