Disconnect the left fan cable from the system board.
2. Remove the two (M2x4) screws that secure the left fan to the palm-rest and keyboard assembly.
3. Lift the left fan to remove it from the palm-rest and keyboard assembly.
After the fan cable is disconnected and the screws that are removed, lift the fan from its outer edge and slide it away from
the system.
NOTE: The image above shows the process for the left fan. The same process applies to the right fan.
Installing the left fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
26
Removing and installing components
To Next Page
Loading...
