Installing the heat-sink for integrated graphics
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the heat-sink and provides a visual representation of the installation procedure.
Steps
1. Align and insert the heat-sink into its slot on the system board.
2. Tighten the four captive screws that secure the heat-sink to the system board.
NOTE: Loosen the captive screws in the order that is marked on the heat-sink next to the screws [1 > 2 > 3 > 4].
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the heat-sink for discrete graphics
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the heat-sink and provides a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
