EasyManua.ls Logo

Dell Precision 5490 - Battery; Rechargeable Li-Ion Battery Precautions; Removing the Battery

Dell Precision 5490
135 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery
Rechargeable Li-ion battery precautions
CAUTION:
Exercise caution when handling rechargeable Li-ion batteries.
Discharge the battery completely before removing it. Disconnect the AC power adapter from the computer
and operate the computer solely on battery powerthe battery is fully discharged when the computer no
longer turns on when the power button is pressed.
Do not crush, drop, mutilate, or penetrate the battery with foreign objects.
Do not expose the battery to high temperatures, or disassemble battery packs and cells.
Do not apply pressure to the surface of the battery.
Do not bend the battery.
Do not use tools of any kind to pry on or against the battery.
Ensure any screws during the servicing of this product are not lost or misplaced, to prevent accidental
puncture or damage to the battery and other computer components.
If the battery gets stuck inside your computer as a result of swelling, do not try to release it as puncturing,
bending, or crushing a rechargeable Li-ion battery can be dangerous. In such an instance, contact Dell
technical support for assistance. See www.dell.com/contactdell.
Always purchase genuine batteries from www.dell.com or authorized Dell partners and resellers.
Swollen batteries should not be used and should be replaced and disposed properly. For guidelines on how to
handle and replace swollen rechargeable Li-ion batteries, see Handling swollen rechargeable Li-ion batteries.
Removing the battery
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the battery and provides a visual representation of the removal procedure.
NOTE:
For models shipped with WLAN antennas, unroute the cables from the upper-right side of the battery before
battery removal and then tuck the cables back into the routing channels when reinstalling the battery.
Removing and installing Field Replaceable Units (FRUs) 55

Table of Contents

Related product manuals