Figure 33. Installing the base cover
Steps
1. Connect the battery cable to the connector on the system board.
2. Slide the base cover into its slot until it clicks into place and replace the eight torx screws (T5, M2x3) to secure the base
cover to the computer.
Next steps
Follow the procedure in After working inside your computer.
M.2 solid state drive
Removing the M.2 2230 solid state drive
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
NOTE: For computers shipped with M.2 2230 solid state drive.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
Removing and installing Field Replaceable Units (FRUs)
49
To Next Page
Loading...
