Steps
1 Place the hard drive into the hard-drive bracket.
2 Align the screw holes on the hard-drive bracket with the screw holes on the hard drive, and then replace the four screws (M3x3) that
secure the hard-drive bracket to the hard drive.
3 Connect the interposer to the hard-drive assembly.
4 Align the screw holes on the hard-drive assembly with the screw holes on the palm-rest and keyboard assembly.
5 Replace the three screws (M2x4) that secure the hard-drive assembly to the palm-rest and keyboard assembly.
6 Connect the hard-drive cable to the system board.
Next steps
1 Connect the battery cable.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
About this task
The gure indicates the location of the speakers and provides a visual representation of the removal procedure.
Disassembly and reassembly
31
To Next Page
Loading...
