Dell Vostro 7590 - Removing the M.2 2230 Solid-State Drive; Installing the M.2 2230 Solid-State Drive

Next step
1 Connect the battery cable.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Removing the M.2 2230 solid-state drive
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Disconnect the battery cable.
About this task
The gure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the removal procedure.
Steps
1 Remove the screw (M2x4) that secures the solid-state drive to the palm-rest and keyboard assembly.
2 Slide and remove the solid-state drive module from the solid-state drive slot on the system board.
Installing the M.2 2230 solid-state drive
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The gure indicates the location of the solid-state drive bracket and provides a visual representation of the bracket alignment procedure to
accommodate the M.2 2230 solid-state drive.
Disassembly and reassembly
25