Steps
1 Remove the three (M2x3) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
2 Lift the touchpad bracket o the palm-rest and keyboard assembly.
3 Open the latch and disconnect the touchpad cable from the system board.
4 Remove the two (M1.6x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
5 Lift the touchpad, along with the cable, o the palm-rest and keyboard assembly.
Installing the touchpad
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The gure indicates the location of the component and provides a visual representation of the installation procedure.
Disassembly and reassembly 51
To Next Page
Loading...
