Dell Vostro 7590 - Display Assembly; Removing the Display Assembly

Steps
1 Align and place the touchpad into the slot on the palm-rest and keyboard assembly.
2 Replace the two (M1.6x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
3 Slide the touchpad cable onto its connector on the system board and close the latch to secure the cable.
4 Align and place the touchpad bracket into the slot on the palm-rest and keyboard assembly.
5 Replace the three (M2x3) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
Next step
1 Install the speakers.
2 Install the battery.
3 Install the base cover.
4 Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Remove the battery.
4 Remove the WLAN card.
About this task
The gure indicates the location of the display assembly and provides a visual representation of the removal procedure.
52
Disassembly and reassembly