Steps
1 Align the notch on the solid-state drive module with the tab on the solid-state drive slot.
2 Slide the solid-state drive module rmly into the solid-state drive slot at an angle.
3 Replace the screw (M2x4) that secures the solid-state drive module to the system board.
Next step
1 Connect the battery cable.
2 Install the base cover.
3 Follow the procedure in After working inside your computer.
Hard drive
Removing the hard drive
Prerequisites
1 Follow the procedure in Before working inside your computer.
2 Remove the base cover.
3 Disconnect the battery cable.
About this task
The gure indicates the location of the hard drive and provides a visual representation of the removal procedure.
NOTE
: The hard drive is available only in computers shipped with 3-cell battery.
28 Disassembly and reassembly
To Next Page
Loading...
